Being new to CF, what adjustments do I need to make to the car to go from Vintage treaded tires to slicks?
Thanks
Being new to CF, what adjustments do I need to make to the car to go from Vintage treaded tires to slicks?
Thanks
Johhny Reisert
Assuming you are switching to scca legal slicks, which are radials, as a minimum you'll want lots more camber, like 3-3.5 degrees vs 0.5 degrees, and you'll also want to check ride height due to diameter differences. Radials want slightly higher hot pressure.
Secondary changes once you've driven it may be spring and bar rates.
Ian Macpherson
Savannah, GA
Race prep, support, and engineering.
NEDIV CF Rules are: "Tire choice is restricted to three (3) racing slick options: Goodyear 600, Hoosier 60, American Racer AR133."
I believe all are bias ply.
I went from slicks to the treaded Hoosier VFF (due to cost), which are now legal for CFF in the northeast. If you run on the SCCA spec radial, your in FF.
All I did was take out the camber to run the treaded VFF tire. Just add camber and you should be OK to run slicks.
Last edited by AlanVDW; 10.04.24 at 7:15 PM.
Van Diemen RF 79 #? Van Deimen RF 78 #231
It's not how fast you go.
It's how well you go fast.
Yup. Jake's correct. The front treaded tires are about 3" larger, and the rears are about 1.5" larger, in circumference. I thought my Lime Rock gearing seemed a bit tall, although I was really slow anyway after 12 yrs off. So, my car may be taller, but I will still need to check the rake. I only changed camber to 1/4 degree negative, readjusted the toe, and increased the tire pressure to run the treaded tires.
Van Diemen RF 79 #? Van Deimen RF 78 #231
It's not how fast you go.
It's how well you go fast.
There are currently 5 users browsing this thread. (0 members and 5 guests)