WTB: FF 92ish Parts

[reidhazelton]

In search of:

1. Left bellcrank for a 92 (might be a one year only, not sure)
2. Left rear lower control arm (preferably off an FC)
3. Front monoshock shuttle axle thing (shown in the photo)
4. Axle (20" long. 33 spline, drilled)

[David Clubine]

I have new axles in stock. PM me if you want to discuss. Cheers

[TimH]

I have new axles in stock. PM me if you want to discuss. Cheers

Any chance you have shuttle springs?

[reidhazelton]

Any chance you have shuttle springs?

Hi Tim,
The springs are readily available. Search "die springs" or "punch press springs." These springs are commonly used to eject press/stamping dies and are readily available.

[David Clubine]

Any chance you have shuttle springs?

I don't, but as Reid suggests, die springs.....

[TimH]

I've been through pages and pages of online die spring suppliers and have never found exact replacements for the RF94. Our last resort will be get some that are about 2x too long and cut them down, with calculations on how that changes the rates. I keep hoping for an easier solution, maybe with ends already ground flat.

Brad at Primus thought he had some, but they turned out to be quite different dimensions, too.

Sorry to hijack your post Reid.

[David Clubine]

I've been through pages and pages of online die spring suppliers and have never found exact replacements for the RF94. Our last resort will be get some that are about 2x too long and cut them down, with calculations on how that changes the rates. I keep hoping for an easier solution, maybe with ends already ground flat.

Brad at Primus thought he had some, but they turned out to be quite different dimensions, too.

Sorry to hijack your post Reid.

The RF94 is a larger diameter spring than the 92. Some of the guys up here back when those cars were new used Belleville washers. Just a thought.