this is my first go at a dry sumped motor and I have a couple of questions re relieving the pressure from the top and bottom end of the motor .
I have searched the pictures and info on this forum and cannot find a definitive answer.
the hole in the block near the fuel pump .
should there be a hose from this hole to relieve
the bottom end pressure ?
if so what size ID hose and where does it go to ?
into the catch tank or the dry sump oil reservoir ?
or should it be blocked off ?
the same question for the hose from the valve cover
what size ID?
where does it go to ?
and the overflow spout from the dry sump oil reservoir
does it go straight into the catch tank ?
1600 cc kent formula ford motor
thanks
mal