p58 of the October Fastrack
http://scca.com/_FileLibrary/File/06-10-fastrack.pdf [SIZE=1][/SIZE][SIZE=1]1. [/SIZE]
[SIZE=1]Section 17.1.6.D.6.d, clarify the section by adding as follows: A stress-bearing floor pan/undertray, minimum of .060" heat treated aluminum or eighteen (18) gauge steel, is required; [/SIZE][SIZE=1]at a minimum this shall extend f[/SIZE][SIZE=1]rom the front bulkhead to the rear roll hoop bulkhead. Its curvature shall not exceed one inch.[/SIZE]
[SIZE=1]
[/SIZE]
[SIZE=1](Italics are from the original).
James
[/SIZE]