Advanced Search
Register
or
Login
Login to Your Account
Remember Me?
Register
forum
hot topics
Reset Password
Activity Stream
New Posts
New Events
Mark Forums Read
advertising
merchandise
Home
Activity Stream
If this is your first visit, be sure to check out the
FAQ
by clicking the link above. You may have to
register
before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Activity Stream
Filter
Sort By
Time
Show
Recent
Recent
Popular
Popular
Anytime
Anytime
Last 24 Hours
Last 24 Hours
Last 7 Days
Last 7 Days
Last 30 Days
Last 30 Days
All
All
Photos
Photos
Forum
Forums
Articles
Articles
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
09.26.24,
2:10 PM
scotty82
replied to a thread
Ozark gearing
in
General Formula Car Discussion
i just ran these charts for a couple customers 9-31 @6800 with a 23 tire 19-33=77.6 mph 21-30=94.5 mph 23-28=110.7 mph 24-26= 125.1 mph ...
see more
1 replies | 251 view(s)
09.26.24,
1:56 PM
lwbarron
started a thread
Ld200
in
FC: Classifieds: Parts For Sale
LD200 Transmission For Sale: Rebuilt by David Clubine at Britian West. New 10:31 Ring and Pinion, New Bearings Steel Differential Everything REM...
see more
0 replies | 7 view(s)
09.26.24,
1:35 PM
cmiller
started a thread
1978 Lola T440, frame-up rebuild by JDC Motorsports
in
FF: Classifieds: Cars For Sale
1978 Lola T440 -One owner. Purchased new in 1983 from Carl Haas Auto. -SCCA Log Book 78-112 -11 Total Races -1 race since full frame-up rebuild...
see more
0 replies | 30 view(s)
09.26.24,
12:24 PM
Robert J. Alder
replied to a thread
Engine ID ?
in
FF: General Discussion
"Bandit" motors were built by Bill Bradford in Denver. I'd guess in the early '80s. He and John Barker (the Second Creek Raceway operator back then)...
see more
1 replies | 103 view(s)
09.26.24,
11:46 AM
Charlie Schmidt
started a thread
Engine ID ?
in
FF: General Discussion
Can anyone tell me who "Bandit Motors" is, or was? A recently acquired engine has it stamped into the front of the head A note that came with would...
see more
1 replies | 103 view(s)
09.26.24,
11:30 AM
J Leonard
replied to a thread
Radiator Intake Pod Stone/Debris Screen Size
in
General Formula Car Discussion
Mcmaster-Carr for wire cloth. Opening size, wire size and percent open area listed.
see more
3 replies | 263 view(s)
09.26.24,
11:00 AM
DaveW
replied to a thread
Radiator Intake Pod Stone/Debris Screen Size
in
General Formula Car Discussion
https://www.apexspeed.com/forums/showthread.php?97592-Radiator-screens&highlight=radiator+screen Also, the large bypass area outside of the...
see more
3 replies | 263 view(s)
09.26.24,
10:54 AM
Phil Creighton
replied to a thread
78-80 Van Diemen lower front A-arm design
in
FF: Club Ford
Steve i think from my memory at VD in 78 that the wishbones did vary depending on whether Arch or Sabre made them. None were made at VD in those...
see more
1 replies | 162 view(s)
09.26.24,
10:42 AM
Phil Creighton
replied to a thread
WANTED: Hewland MK8 12-11/16" 'long' Input Shaft
in
Vintage: Classifieds: Wanted
Try the lotus 23 sources in the uk like Peter Denty or PDS From memory the Lotus 23 is a 3" bellhousing on a twin cam with a 7/8 x 20 clutch spline...
see more
3 replies | 259 view(s)
09.26.24,
9:56 AM
Rick Kirchner
replied to a thread
Radiator Intake Pod Stone/Debris Screen Size
in
General Formula Car Discussion
Optimum size depends entirely on your circumstances - radiators, engine HP, location, etc. Years ago I used some aluminum honeycomb to fill in the...
see more
3 replies | 263 view(s)
09.26.24,
12:46 AM
Davrian1300
replied to a thread
WANTED: Hewland MK8 12-11/16" 'long' Input Shaft
in
Vintage: Classifieds: Wanted
Much appreciated
see more
3 replies | 259 view(s)
09.25.24,
8:46 PM
EYERACE
replied to a thread
Live timing
in
General Events and Track Info
Racehero.io ???
see more
4 replies | 691 view(s)
09.25.24,
7:30 PM
Rick Iverson
started a thread
Radiator Intake Pod Stone/Debris Screen Size
in
General Formula Car Discussion
Gents: Optimum size and source, please. Is this too big?
see more
3 replies | 263 view(s)
09.25.24,
7:26 PM
Skelly
replied to a thread
F4 wheel
in
F4: Classifieds: Cars & Parts For Sale
Wheel needs to go. A good spare or maybe for a rain tire. $50 plus shipping. Thanks Sean sean1882@att.net
see more
4 replies | 3240 view(s)
09.25.24,
7:24 PM
Skelly
replied to a thread
Transport Wheels
in
FB: Classifieds: Parts For Sale
Another set finished for a Stohr FB car. Please email me if you are looking for a set. Any bolt pattern can be made. Thanks Sean...
see more
1 replies | 3419 view(s)
09.25.24,
6:58 PM
Raltracer
started a thread
RT4 side plates
in
FA: Classifieds: Wanted
Looking for FT205 & FT206 for FT200. OUTBOARD brakes with shock mount bottom of plate. Thanks Peter
see more
0 replies | 71 view(s)
09.25.24,
6:54 PM
Raltracer
replied to a thread
RT4 side plates
in
Vintage: Classifieds: Wanted
Outboard brakes with shocker mount bottom of plate
see more
3 replies | 359 view(s)
09.25.24,
6:47 PM
J Leonard
replied to a thread
RT4 side plates
in
Vintage: Classifieds: Wanted
Does the RT4 have inboard brakes using the FT205B and FT206B?
see more
3 replies | 359 view(s)
09.25.24,
6:39 PM
Steve Robertson
started a thread
78-80 Van Diemen lower front A-arm design
in
FF: Club Ford
The photos show two versions of lower front A-arms for the 78-80 VD. The one on the right is a front lower right and the one on the left is a front...
see more
1 replies | 162 view(s)
09.25.24,
6:36 PM
Rick Iverson
replied to a thread
WANTED: Hewland MK8 12-11/16" 'long' Input Shaft
in
Vintage: Classifieds: Wanted
Let me check my inventory.
see more
3 replies | 259 view(s)
09.25.24,
1:24 PM
Davrian1300
started a thread
WANTED: Hewland MK8 12-11/16" 'long' Input Shaft
in
Vintage: Classifieds: Wanted
Hi all, I'm looking for a Hewland Input Shaft to suit the Mark 8 and 9 type gearboxes with the thicker (Lotus) 3-1/4" engine adapter, the shaft...
see more
3 replies | 259 view(s)
09.25.24,
12:22 PM
dlrugh
replied to a thread
RT4 side plates
in
Vintage: Classifieds: Wanted
I have both from an RT4? David
see more
3 replies | 359 view(s)
09.25.24,
11:34 AM
10rmotor
replied to a thread
New Miller welding cable
in
Open Motorsports Classifieds
Sent you a PM with all the details Thanks!
see more
5 replies | 843 view(s)
09.25.24,
9:47 AM
essex
replied to a thread
New Miller welding cable
in
Open Motorsports Classifieds
Yes, still available - let me have your address and I can work out the postage. Payment can be via PayPal or check Thanks Michael
see more
5 replies | 843 view(s)
09.25.24,
9:12 AM
Steve Davis
replied to a thread
Live timing
in
General Events and Track Info
Links to timing, audio and video won't become LIVE until they start broadcasting. Pretty sure they intend to broadcast all the test days as well as...
see more
4 replies | 691 view(s)
09.25.24,
8:43 AM
reidhazelton
replied to a thread
Kephos alternative than Keco Coatings?
in
General Formula Car Discussion
Credit where credit is due: After a talk with Keco, they made the situation right without any fight at all (which I was expecting). So while the...
see more
9 replies | 1898 view(s)
09.25.24,
8:37 AM
Rob S
replied to a thread
1989 Euroswift SE-1 For Sale
in
FF: Classifieds: Cars For Sale
There is 1 new uninstalled lower right rear panel. There is also the mold for the nose cone and the roll bar hoop piece
see more
2 replies | 2826 view(s)
09.24.24,
11:22 PM
Fast Finn
started a thread
1998 Van Demon
in
FA: Classifieds: Cars For Sale
1998 Van Demon FB / FA for sale lots of spares . Asking $40,000 , will be bringing it to Homestead and Sebring majors unless it sells . I’m...
see more
0 replies | 329 view(s)
09.24.24,
9:33 PM
Jamez
replied to a thread
Swift DB4 Staffs CWP
in
FA: General Discussion
Hewland can make them. I had a new hewland one in mine until a friend had a drive. I then found a used Hewland one to replace it.
see more
1 replies | 292 view(s)
09.24.24,
9:25 PM
glm34
replied to a thread
Camber Shims for RFR
in
FC: Classifieds: Wanted
PM me your address. I will send one front and one rear. Try before you buy.
see more
11 replies | 1510 view(s)
More Activity
No More Results
No Recent Activity