Jeez, why is this so complicated?
I'm re-plumbing my Titan Series 2 dry sump system in order stem leakage.
All is good until I try to find the right fittings for the inlet to the pressure side of the pump.
Titan fitting is a 5/8 BSP male. The inlet hose from the oil sump is 3/4 ID.
I thought I could find a 3/4" barbed fitting to fit the hose to the 5/8 BSP.
No luck.
I looked for a 5/8 BSP adapter (female BSP to AN) but the closest I can find is 8 AN with a 1/2" barb. Would need a 12 AN for a 3/4" hose.
Anyone have a way to do this?
Thanks in advance!