Block

[Charles Warner]

Need a non-usable Ford 1600 block as a mock-up for a formula atlantic. Cracked, exploded, doesn't matter as long as the engine mounts and rear face are intact.

[DanW]

Hello Charles,

I have both a FF 711 block and a 681 Twincam block that I probably will never use (both have been sleeved). You are welcome to either. I can ship from my old job at a fairly decent discounted freight rate. Block in a crate is about 90-95 lbs.

Regards,
Dan

[Charles Warner]

Thanks Dan. I’m not sure of any differences between the two. What do you want for the 711 block?

Hello Charles,

I have both a FF 711 block and a 681 Twincam block that I probably will never use (both have been sleeved). You are welcome to either. I can ship from my old job at a fairly decent discounted freight rate. Block in a crate is about 90-95 lbs.

Regards,
Dan

[DanW]

I think there's a difference in the overall width between the motor mount bosses. I will measure and advise. 711 deck height is 1/2" taller I believe.

[Charles Warner]

Deck height not a factor. Need it to bolt into a Ralt RT4 for mock up. I believe the 711 is the same ad the BDA block

I think there's a difference in the overall width between the motor mount bosses. I will measure and advise. 711 deck height is 1/2" taller I believe.

[Offcamber1]

Charles, I have one I can loan you for a good while. I'll be passing through Memphis Tuesday afternoon.

Kip

[DanW]

Kip has an even better deal.