Gents;
I have a NEW, never mounted Keith Averill nose box/crush structure available.
I paid $448.78 including shipping and Insurance, I’ll take $400 to you.
V/r
Iverson
Gents;
I have a NEW, never mounted Keith Averill nose box/crush structure available.
I paid $448.78 including shipping and Insurance, I’ll take $400 to you.
V/r
Iverson
Last edited by Rick Iverson; 12.24.19 at 8:18 PM.
What model VD, RF?
Sean
Rf94/95 for sure.
Last edited by Rick Iverson; 05.19.20 at 6:06 PM.
Does it fit the 96 car? And perhaps a picture might help if it looks different from the standard 95 part.
Skip Weld
Bump. This baby is nice
V/r
Iverson
Bump
V/r
Iverson
Very Nice! Great workmanship!
Too bad I dont need one!
How wide is it across the top in the back where it mounts? 6 inch or 7 inch?
I measured the width of the chassis mounting holes at 8.0”
V/r
Iverson
Bump
V/r
Iverson
$325 plus s/h/i
V/r
Iverson
Bump
V/r
Iverson
Looking for an ST8100. Barter?
V/r
Iverson
This time.........because I got it wrong last time............how wide is the "pointy end" ? 6" or 7" ?
I didn't realize it but for years my car had one with a 6" front......and matching body work. When I messed up the box all I could find was 7" fronts and therefore had to change my body work nose to a wider one. I'd like to get the narrower nose back on with a 6 incher. No idea where the guy that put the car together up in Michigan came up with the narrow stuff. It's also caused the front wing tube to be a problem so I can only, until I address it, run one set of wings.
Stan;
This is a stock replacement RF94/5 crush structure that measures 8.875” wide at the pointy end.
V/r
Iverson
Pending
V/r
Iverson
There are currently 1 users browsing this thread. (0 members and 1 guests)