FV Shop Clean out

[Germg]

I am cleaning out the shop for good. Everything must go away.
Torque Master Tool sold
Carb Jet Kit(everything in the picture) sold
Throttle Cable New Transporter Sold
K&N Air Filter New Sold
Fox Shock Shims and Stacks Sold
Neal Pull Type Slave Cylinder sold
Oil Pumps (1 full flow sold, 2 stock flow) $Sold each
Oil filler (1 OE sold, 1 new style) Sold each
Oil Cooler Cover plates(2 no bypass, 2 with external cooler bypass) Sold each
Oil Filter Bolt on Mounting Blocks(1 Small, 1 Large) Sold each
Remote Oil Filter Housings Sold each
Velocity Stacks(2 Tall Never Fit Sold, 1 Small Radius, 1 Large Radius) Sold Each
Valve Covers 8 Sold each
Valve Cover Bail 3 Sold each
Valve Cover Gaskets Lot for Sold(more than pictured)
3 Rear Axles sold each
Gaskets sold for everything in pic
Rear Axle bearing seal kit 3 sold each
Rear Axle Gaskets and Large O-ring sold for all of them
2 New Distributor Caps sold each
2 New Distributor Rotors sold each
New Fuel Pump Sold
Taylor Spark Plug Wires New sold
Slanted Brake Adjusters 5 Sold each
Engine Tools 4 Sold
New Clutch Assembly, Spring type with disc Sold
New Throw Out Bearing Sold
3 Throw Out Bearing Arms Sold each
3 Hockey Sticks (Trans) sold each

Please make an offer if I did not list it but it is in the picture.

Thanks
Jeremy
Ski Motorsports

[lucky13]

I’ll take the plug wires, slave cylinder, distributor caps, rotors, rear axle bearing seal kits.

[pacratt]

PM sent.

Glenn

[Matt Clark]

Jeremy,
are those light axles, or standard ones?

[Amon]

I’ll take the plug wires, slave cylinder, distributor caps, rotors, rear axle bearing seal kits.

Matt,

Are you heading back out onto the track again?


Mark

[lucky13]

Matt,

Are you heading back out onto the track again?


Mark

Mark,
i wish I could say that I was, but prepping two F1600 cars and crewing takes up every minute of my time. I haven’t given up on driving and would love to come out for the Challenge Cup but almost all of the races are with FRP. I guess I’m just stockpiling parts and should probably think about selling one of the Vees.

Sorry for hijacking the thread.

Matt

[fvracerone1]

Do you still have the front bearing pinch nuts?

Frank V

[carby]

If you need some I make them


Arnie

Do you still have the front bearing pinch nuts?

Frank V

[predator p3-05]

Jeremy,

I could use the throttle cable, velocity stack, and the clutch arm with the split collar.