FF: Classifieds: Parts For Sale
Ivey Engine
SOLD
Kent 1600 FF Engine
Jay Ivey Engines, Inc. #0124
This engine came from a Reynard RF82
that I am parting out. It was originally built by Jay Ivey in 2001. I
don't know its history since then. I called Ivey and he sent me the
dyno data from the original build. Send me your email and I can
forward a copy to you. The previous owner of the car autocrossed it.
I have not raced the car since I bought it in 2014.
Crankshaft: Cast Iron
Cylinder Head: Cast Iron
Pistons: Cast Aluminum
Oil Pump: BAT 5 port
Distributor: Motorcraft
Clutch: Stock Ford
Not included:
Starter
Exhaust
Air Filter
Coil
I recently did a test run in the garage and it started up easily and ran smoothly.
Oil pressure was 55-60 psi, dropping to 50psi after about 15 minutes of running
when the water temperature was 90 deg. C. (The car did not have an oil
temperature gauge).I did a leakdown test and all cylinders were 3-5
psi. This compares well with other engines as they came from pro
builders which I tested with this same tester, (A Snap-on MT324).
$3500 plus shipping from 63303.
Message or email me if you have any questions.
Reply With Quote
Originally Posted by fvracerone1
