I am going to have a proper right hand exit SS header made for my car and wanted to see if there was any interest towards a group buy of sorts.
I am actually running the same GSXR header from RFR on my Kawi - It actually bolts up to either engine w/ very little modification; basically bending the last few inches of the head pipe upwards.
My plan is to have one exhaust work with either engine, and made to mimic the factory header. The header which comes with the car, while rather robust, is not very close to optimal - primary lengths, collector location, and tube diameter could all be improved upon.
Here is a sample of my guy's work, which was for a Radical w/ Hayabusa iirc...
Obviously the header shown does NOT have anywhere near the space limitations as our cahssis does, hence the "stacked" or whatever design.
I'd like to get a gauge on interest, and if warranted, a jig would be made off my original pipe to build exact replicas. I will be bringing him the rear half of my car immediately after the Watkins Glen race.
These headers may fit other chassis, some with minimal to no mods.
My plan is for a straight up dump in the vicinity of the clutch cover area...
PM me with any interest - cost to be determined by number of headers.