Hi I have a several sets of 2.25” ID race spring for sale in Berkeley, CA. These springs have seen very little (if any) use on a Formula SAE car. All money from the sales of these springs will go to the UC Berkeley Formula SAE team. They are all clean except for a few nicks in the coating near the mounting faces of the springs. All but 3 sets of the springs are Eibach and have measured rates on them. However, I am unsure how the rates were measured. Here is the list of stuff. I would prefer local, but am willing to ship.


All Springs are 2.25” ID


2x Eibach 6” Free length 700lbs/in (measured rate: 698lbs/in and 698lbs/in) Eibach Part no. 0600.225.0700




2x Eibach 6” Free length 750lbs/in (measured rate: 736lbs/in and 763lbs/in) Eibach Part no. 0600.225.0750




2x Eibach 4” Free length 1100lbs/in (measured rate: 1091lbs/in and 1081lbs/in) Eibach Part no. 0400.225.1100


The Eibachs go for $89.99 new at http://www.vacmotorsports.com/cgi-bi....pl?man=Eibach . So considering the condition these are in I will sell all the springs for $75 a piece.


I also have 3 sets of an unknown brand of spring. They look to be of good quality, but there is no labeling on them except for a “made in england tag”, they are coated in black, perhaps they are Rockwell springs? Anyways I don't believe these guys have been measured but there are rates engraved on the ends of them.


4x 2.25” ID x 4” Free length at 450lbs/in


2x 2.25” ID x 4” Free length at 575lbs/in (these guys have the made in England tag on them, but the 3 sets look like the same kind of spring except for rate.)


I will sell each of these “made in England” springs for $50 a piece.




Thank You
-Nihal Murthy


You can reach me by e-mail at: nihal@berkeley.edu




http://fsae.berkeley.edu