RTS wheels , 6 and 8

[Lotus7]

STILL AVAILABLE

For Van Diemen, (and maybe others) with 3 3/4 pcd.
Didn't fit the first buyers 1995 front hubs, but they came off our '00, believe anything '99 and up will fit.
$800

Avons have been dismounted since photos were taken.

Pickup here in Connecticut, or Lime Rock on Labor Day?

Will ship but can't imagine it makes sense financially for you. Your call.

[Rick Iverson]

Check you PMs

[Lotus7]

Check you PMs

I’m afraid I don’t see a message

[Lotus7]

I've had some fitment questions that I'm not 100% sure of the answers. Any experts out there know of any reason why a wheel off a year 2000 VD wouldn't fit any unmodified VD from '99 up?
(Or even pre-99's?)

thx

[Lotus7]

RELISTED 3/13/2022

still for sale as of mid June

[David Clubine]

RELISTED 3/13/2022

For Van Diemen, (and maybe others) with 3 3/4 pcd.
Didn't fit the first buyers 1995 front hubs, but believe anything '99 and up will fit.
$800, and you can have the worn Avon's for free. :-)

Pickup here in Savannah, or free delivery to Carolina in April.
Will ship but can't imagine it makes sense financially for you. Your call.

The only reason it shouldn't fit the front 1990-current is perhaps the drive pin diameter. On the 1600's we use the same wheel on 1990 and up center lock cars. But we changed the drive pins on the early cars to match the later cars.

The rear on a 1999 and up has a different offset from the earlier car I believe. They should physically fit however.

[Lotus7]

The only reason it shouldn't fit the front 1990-current is perhaps the drive pin diameter. On the 1600's we use the same wheel on 1990 and up center lock cars. But we changed the drive pins on the early cars to match the later cars.

The rear on a 1999 and up has a different offset from the earlier car I believe. They should physically fit however.

Hi David,
Full disclosure, the buyers 95 VD was a bit of a "bitsa", a converted FF. His front rotors were the single piece rotor+hat, and combined with the LD20's, the foul was with the wheel spokes. These RTS wheels have flat radial spokes with no outward 'bulge' to clear the caliper. The wheel backspace matched those of his compomotives that did clear the caliper.

The wheels do fit our '00 with the separate rotor and hat geometry.

[Lotus7]

bump, these wheels are now in SW Connecticut if my location down south here was an issue for a potential buyer.

[Lotus7]

mid-season bump

[alangbaker]

Can you still find parts for RTS wheels?

[Lotus7]

Can you still find parts for RTS wheels?

I dont know. We got these with a car purchase, they do not need rebuilding at this point.
Selling because we have too many wheels and these are a single set different from all the OZ's.

[Lotus7]

RTS wheels are still available

currently in CT, but can be delivered free to FL (or anywhere along I-95 in early December